New Guard Coatings

PPG SigmaCover 630 LT

PPG SigmaCover 630 LT

Two component, surface tolerant high solids polyamine cured epoxy primer/coating with excellent corrosion and abrasion resistance

PPG Logo

PPG SigmaCover 630 LT

PPG SigmaCover 630 LT is a two-component, surface tolerant high solids polyamine cured epoxy primer/coating with excellent corrosion and abrasion resistance.

 

Product Features and Benefits

  • Self priming coating tolerant to lower grades of steel preparation for atmospheric exposure
  • Cures at temperatures down to -5°C (23°F)
  • Particularly well-suited as maintenance coating for steel structures
  • Excellent corrosion resistance
  • Resistant to splash and spillage of a wide range of chemicals
  • Good abrasion resistance
  • Good flexibility
  • Compatible with various aged coatings
  • Good recoatability with most epoxy, polyurethane, chlorinated rubber, alkyd and acrylic paints

 

Application

  • Air Spray
  • Airless Spray
  • Brush/Roller

Please refer to Data Sheet for application instructions.

 

Colour and Gloss Level

Colours: Grey, off-white (other colours available on request)

Finish: Gloss

 

Recommended Thinner

PPG Thinner 91-92

 

Cleanup

PPG Thinner 90-53

 

Safety Precautions

  • For paint and recommended thinners see Information Sheets 1430, 1431 and relevant Material Safety Data Sheets
  • This is a solvent-borne paint and care should be taken to avoid inhalation of spray mist or vapor, as well as contact between the wet paint and exposed skin or eyes

 

Contact Us

For further advice regarding the use of this product, technical support or a quotation please contact us.

 

Basic Data at 10°C (50°F) for mixed product:

Number of components Two
Mass density 1.4 kg/l (11.7 lb/US gal)
Volume solids 83±2%
VOC (Supplied) Directive 1999/13/EC, SED: max. 190.0 g/kg. UK PG 6/23(92) Appendix 3: max. 268.0 g/l (approx. 2.2 lb/US gal)
Recommended dry film thickness 60 – 150 μm (2.4 – 6.0 mils)
Theoretical spreading rate 13.8 m2/l for 60 μm (555 ft2/US gal for 2.4 mils) 5.5 m2/l for 150 μm (222 ft2/US gal for 6.0 mils)
Dry to touch 12 hours
Overcoating Interval Minimum: 16 hours. Maximum: 2 months
Full cure after 7 days
Shelf life Base: at least 12 months when stored cool and dry. Hardener: at least 24 months when stored cool and dry
Pot life 2 hours at 10°C (50°F)

Please refer to the Data Sheet for additional technical data.

Download Datasheet