PPG Amercoat 385 (SigmaCover 385)
PPG Amercoat 385 is a two component, high-build, multipurpose, polyamide cured epoxy coating.
Pack Size: 5 litres, 20 litres
Product Features and Benefits
- Multi-purpose high build epoxy
- High solids high build epoxy intermediate coat
- Compatibility with a wide range of substrates and surface preparations
- Excellent resistance against chemical spillage
- Amercoat 385 PA contains zinc phosphate for enhanced corrosion inhibitive performance, which is available in US and Asia Pacific only
- Also available with MIO pigmentation
- Amercoat 385 LH is formulated for a lower level of HAPs, which is available only in US
Recommended Uses
- Mild steel
- Galvanised steel
- Stainless Steel
- Non-ferrous metals
- Concrete
Please refer to the Data Sheet for usage instructions.
Substrate Temperature and Application Conditions
- Coating performance is, in general, proportional to the degree of surface preparation
- Abrasive blasting is usually the most effective and economical method. When this is impossible or impractical, coating can be applied over mechanically cleaned surfaces
- All surfaces must be clean, dry and free of all contaminants, including salt deposits. Contact PPG for maximum allowable salt containment levels
- Surface temperature during application should be at least 3°C (5°F) above dew point
- Ambient temperature during application and curing should be between 4°C (40°F) and 50°C (122°F)
- Relative humidity during application should not exceed 85%
Colours
White, black, oxide red, buff, pearl grey
Contact Us
For further advice regarding the use of this product, technical support or a quotation please contact us.