Sherwin Williams Resuflor HB

Sherwin Williams Resuflor HB is a two-pack high performance floor coating providing a hygienic and hard-wearing resin floor system. 

Pack Size: 5kg and 15kg  

Product Description

Incorporating technology based on high solids epoxy resin technology which is designed to provide a tough and durable floor protection finish in a variety of thicknesses and colours for a wide range of applications, Resuflor HB will provide a smooth gloss finish to which anti-slip aggregate can be added if required.  

Product Benefits

• Single coat application up to 500 microns
• Wide range of colours available
• Seamless
• Hygienic
• Easy to clean
• Chemical resistance

Yield

5 kg will cover 17m2 @ 200 microns wet film thickness. *Coverage rate is calculated based on a sealed and smooth surface and may vary based on the substrate roughness and other conditions.  

Colour

Available in a wide range of colours.  

Product Advantages

High-build finish High solids Hygienic and easily cleaned Good colour stability Excellent slip resistance with the inclusion of selected aggregates Excellent high gloss finish  

Recommended Uses

Food processing and beverage areas Chemical plant rooms Engineering workshops Automotive & aviation areas Factory unit floors Warehouses Excellent for all demarcation and walkway areas  

Product Application

Sherwin Williams Resuflor HB is easy to apply by roller and paint brush to create a seamless, hard wearing and hygienic floor finish. The ambient temperatures of the areas should not be allowed to fall below 15o C throughout the application and the curing period, as this could have an adverse effect on the appearance and colour of the system. Surface temperature must be above 10o C. Where possible it is recommended that the application area is heated to a minimum temperature of 15o C ideally to allow the ambient and substrate temperature to stabilise prior to installation.  

Mixing

Pre-mix the coloured base component to a uniform consistency then mix the entire contents of the base with the hardener. If a separate mixing bucket is being used mix thoroughly ensuring all contents of both components are removed from the buckets supplied. Mix using a slow speed electric mixer for approximately two to three minutes until the two components have fully combined. The mixed unit should be applied immediately by roller or brush with a consistent procedure. Floor areas should be cross-rolled to ensure even application and to minimise roller marks  

Contact Us

For further advice regarding the use of this product, technical support or a quotation please contact us.