- DESCRIPTION
- Related Products
- Datasheet
- Reviews
DESCRIPTION
This product is now discontinued, a potential alternative coating would be; Sigmacover 456
Description
Amercoat 385 also known as Sigmacover 385 is a two component high build epoxy coating.
Product Features and Benefits
- Multi-purpose high build epoxy
- High solids high build epoxy intermediate coat
- Compatibility with a wide range of substrates and surface preparations
- Excellent resistance against chemical spillage
- Amercoat 385 PA contains zinc phosphate for enhanced corrosion inhibitive performance, which is available in US and Asia Pacific only
- Also available with MIO pigmentation
- Amercoat 385 LH is formulated for a lower level of HAPs, which is available only in US
Recommended Uses
- Mild steel
- Galvanised steel
- Stainless Steel
- Non-ferrous metals
- Concrete
Please refer to the Data Sheet for usage instructions.
Substrate Temperature and Application Conditions
- Coating performance is, in general, proportional to the degree of surface preparation
- Abrasive blasting is usually the most effective and economical method. When this is impossible or impractical, coating can be applied over mechanically cleaned surfaces
- All surfaces must be clean, dry and free of all contaminants, including salt deposits. Contact PPG for maximum allowable salt containment levels
- Surface temperature during application should be at least 3?C (5?F) above dew point
- Ambient temperature during application and curing should be between 4?C (40?F) and 50?C (122?F)
- Relative humidity during application should not exceed 85%
Colours
White, black, oxide red, buff, pearl grey
Contact Us
For further advice regarding the use of this product, technical support or a quotation please contact us.
Related Products
-
PPG Sigma EP 110 Primer
This product has been discontinued, for a suitable alternative please call us for details. Two component zinc phosphate epoxy blast primer/sealer -
PPG Sigma EP 111 Primer
Two component high solids polyamide cured recoatable zinc phosphate epoxy primer. -
PPG Sigma EP 112 Miocoat
This product has been discontinued - for an alternative please call us to discuss. Two component high solids MIO pigmented polyamide cured recoatable epoxy coating.
Reviews
There are no reviews yet.