- DESCRIPTION
- Datasheet
- Reviews
DESCRIPTION
Resuflor HB (formerly known as Resucoat HB) is a two-pack, high performance floor coating, providing a hygienic, easy-clean and hard-wearing resin floor system.
-
- Pack Sizes: 5kg and 25kg
Product Description;
Incorporating technology based on high solids epoxy resin technology which is designed to provide a tough and durable floor protection finish in a variety of thicknesses and colours for a wide range of applications, Resuflor HB will provide a smooth gloss finish to which anti-slip aggregate can be added if required.
Product Benefits;
-
- Single coat application up to 500 microns
-
- Wide range of colours available
-
- Seamless
-
- Hygienic
-
- Easy to clean
-
- Chemical resistance
Yield;
5 kg will cover *17m2 @ 200 microns wet film thickness. *Coverage rate is calculated based on a sealed and smooth surface and may vary based on the substrate roughness and other conditions.
Standard colours;
RAL 7035, RAL 7038, RAL 7040, RAL 7042, RAL 7043, RAL 6002, RAL 5017, RAL 1032, RAL 3020, RAL 3011, RAL 9011, RAL 9003 Also available in a wide range of non-standard colours.
Product Advantages;
-
- High-build finish
-
- High solids
- Hygienic and easily cleaned
- Good colour stability
-
- Excellent slip resistance with the inclusion of selected aggregates
-
- Excellent high gloss finish
Recommended areas of use;
-
- Food processing and beverage areas
-
- Chemical plant rooms
-
- Engineering workshops
-
- Automotive and aviation areas
-
- Factory unit floors
-
- Warehouses
-
- Excellent for all demarcation and walkway areas
Product Application; Resuflor HB is easy to apply by roller and paint brush to create a seamless, hard wearing and hygienic floor finish. The ambient temperatures of the areas should not be allowed to fall below 15°C throughout the application and the curing period, as this could have an adverse effect on the appearance and colour of the system. Surface temperature must be above 10°C. Where possible it is recommended that the application area is heated to a minimum temperature of 15°C ideally to allow the ambient and substrate temperature to stabilise prior to installation. Mixing; Pre-mix the coloured base component to a uniform consistency then mix the entire contents of the base with the hardener. If a separate mixing bucket is being used mix thoroughly ensuring all contents of both components are removed from the buckets supplied. Mix using a slow speed electric mixer for approximately two to three minutes until the two components have fully combined. The mixed unit should be applied immediately by roller or brush with a consistent procedure. Floor areas should be cross-rolled to ensure even application and to minimise roller marks
Reviews
There are no reviews yet.